color picker problem?

postalgbv · Post by **postalgbv** » Wed Feb 18, 2009 9:38 pm

I noticed a possible issue regarding the color picker. If you go to color preferences and select one, then pick more colors and custom, then drag the crosshair to the upper left or right to one of the reds, the value slider does not correspond correctly, and if you click on the up/down arrows to control hue/sat/lum, it jumps to different area. I think possibly the # value is being applied to the blue.

Post by **MecSoft Support** » Thu Feb 19, 2009 10:47 am

Are you talking about the Rhino color picker here? If so please report this to the Rhino folks. Otherwise please be a bit more explicit in which dialog that you are referring to. Thanks.

postalgbv · Post by **postalgbv** » Thu Feb 19, 2009 10:59 am

this image should show you. It's the color picker that appears when setting machining colors within Rhinocam. Notice I have red selected, but the luminance slider is not correct and changes the color if used. So does changing the up/down arrows seen on the Hue/Sat/Lum.

Post by **MecSoft Support** » Thu Feb 19, 2009 11:14 am

Ok, thanks we will look at this.