Hi all,
On my Vista 64 install of RhinoCAM, the tool library does not load at startup of RhinoCAM 2. I see it flash briefly as if it's already loaded when the program opens - if I have the tool browser open - then it just disappears!!! --Mitch
Tool library not loaded on startup Vista64
-
- Posts: 488
- Joined: Wed Aug 01, 2007 4:15 pm
- Location: Switzerland
- Contact:
-
- Posts: 488
- Joined: Wed Aug 01, 2007 4:15 pm
- Location: Switzerland
- Contact:
-
- Posts: 488
- Joined: Wed Aug 01, 2007 4:15 pm
- Location: Switzerland
- Contact:
-
- Posts: 2405
- Joined: Wed Aug 01, 2007 4:15 pm
- Location: Irvine, CA, USA
- Contact:
Mitch,
Tool library loading at start-up will be fixed on the next update of RhinoCAM 2.0
Here is simple a workaround.
Open Rhino and load a tool library from the cutting tools browser. Save this as Rhino file (*.3dm). Create a shortcut of this file on your desktop.
Launch Rhino by selecting this shortcut. Your tools would now be part of this file. You open additional files using File->Import.
Tool library loading at start-up will be fixed on the next update of RhinoCAM 2.0
Here is simple a workaround.
Open Rhino and load a tool library from the cutting tools browser. Save this as Rhino file (*.3dm). Create a shortcut of this file on your desktop.
Launch Rhino by selecting this shortcut. Your tools would now be part of this file. You open additional files using File->Import.
-
- Posts: 2405
- Joined: Wed Aug 01, 2007 4:15 pm
- Location: Irvine, CA, USA
- Contact:
The issue of tool library not being loaded at startup has been fixed in RhinoCAM 2.0.1.12
For more information check the announcement at:
http://www.mecsoft.com/phpbb/viewtopic.php?t=1691
For more information check the announcement at:
http://www.mecsoft.com/phpbb/viewtopic.php?t=1691