toolpath editing in RhinoCAM
-
- Posts: 3
- Joined: Wed Aug 01, 2007 4:15 pm
- Location: Kerrville, TX
toolpath editing in RhinoCAM
Can you graphically select a toolpath point to edit in the toolpath editor in RhinoCAM? I have a dense toolpath and there are two spikes that I would like to edit out and it is difficult to get to them by selecting block moves until I get to them. Is there a fast way to step through the toolpath to get to them?
-
- Posts: 2405
- Joined: Wed Aug 01, 2007 4:15 pm
- Location: Irvine, CA, USA
- Contact:
toolpath editing in RhinoCAM
No, in RhinoCAM you cannot graphically select the toolpath. You can only select using the list control in the toolpath editor dialog.
-
- Posts: 3
- Joined: Wed Aug 01, 2007 4:15 pm
- Location: Kerrville, TX
toolpath editing in RhinoCAM
Thanks, I will add to this to the enhancement requests