I wonder if anyone can help. I am trying to set the bridge/tab location. I have done this before many times by creating a machining region and manually setting the bridge points. Then I select that pre-definied region for the 2.5 axis profiling but the bridges do not get placed where I have set the locations.
I enclose my simple project here and you can see the bridges in the incorrect location on the last two perimeter tool paths. Any help or advice is appreciated.
Bridge Tab Location not working...
-
- Posts: 4
- Joined: Mon Jun 03, 2019 11:15 am
Bridge Tab Location not working...
- Attachments
-
- Cutting Board.3dm
- (702.8 KiB) Downloaded 545 times
-
- Posts: 2405
- Joined: Wed Aug 01, 2007 4:15 pm
- Location: Irvine, CA, USA
- Contact:
Re: Bridge Tab Location not working...
The file you included does not show any pre-defined machining regions created under Regions tab in machining objects browser. Please attach the file that includes this with bridge points. Alternatively you can send this via email to [email protected].
-
- Posts: 4
- Joined: Mon Jun 03, 2019 11:15 am
Re: Bridge Tab Location not working...
Strange. It shows a predefined region on my screen. I will email to support@mecsoft along with screen grabs of what I am seeing. Thank you for the reply.