Looking at cheap (under $400.00) laser engraver on eBay. Don't have heavy duty need. Should work for me.
The sellers say machine is fully compatible with Corel Draw Laser, Don't know what that entails.
Is there, or could there be, a post for Visual Mill that would work with one of these machines?
Thanks
Tom
CNC laser cutter engraver post?
-
- Posts: 2405
- Joined: Wed Aug 01, 2007 4:15 pm
- Location: Irvine, CA, USA
- Contact:
Re: CNC laser cutter engraver post?
Hi Tom,
If you can provide the details CNC controller that runs the laser engraver & if it reads G & M codes, we can check if a post this is already available or can be developed. If you prefer to email the details, you can send this to [email protected]
Thank you.
If you can provide the details CNC controller that runs the laser engraver & if it reads G & M codes, we can check if a post this is already available or can be developed. If you prefer to email the details, you can send this to [email protected]
Thank you.
Re: CNC laser cutter engraver post?
What I know from reading the brief technical description:
These engravers are compatible with Laser Draw.
These is an open source program called K40 Whisperer which claims to directly support them using a driver called libUSB which is installed by the program Inkscape.
K40 Whisper web page states that it supports importing G code.
If that's enough, great. If not, I may have to learn to speak Chinese.
These engravers are compatible with Laser Draw.
These is an open source program called K40 Whisperer which claims to directly support them using a driver called libUSB which is installed by the program Inkscape.
K40 Whisper web page states that it supports importing G code.
If that's enough, great. If not, I may have to learn to speak Chinese.
-
- Posts: 2405
- Joined: Wed Aug 01, 2007 4:15 pm
- Location: Irvine, CA, USA
- Contact:
Re: CNC laser cutter engraver post?
Thanks for the additional info.
You can select GRBL-Inch or GRBL-MM as your current post processor. This post outputs in standard G & M code format.
You can select GRBL-Inch or GRBL-MM as your current post processor. This post outputs in standard G & M code format.