Back on after long absence - update - missing posts

All discussion related to VisualCAM for SolidWorks
Locked
Bruce Griffing
Posts: 3
Joined: Tue Mar 06, 2012 11:09 am

Back on after long absence - update - missing posts

Post by Bruce Griffing »

I am on Solidworks 2018. I have not used VCfSW or Solidworks for several months. When I logged in today I was notified that there was a more recent version of VC. I downloaded it, but chose not to install since it wanted me to remove old versions. I then tried to set up a job and there are no post processors in the pull down menu. I don't know what happened.
MecSoft Support
Posts: 2405
Joined: Wed Aug 01, 2007 4:15 pm
Location: Irvine, CA, USA
Contact:

Re: Back on after long absence - update - missing posts

Post by MecSoft Support »

Select Post on the Program tab and this would display Set Post Processor Options dialog. Make sure folder where post processor files are located is pointing to C:\ProgramData\MecSoft Corporation\VisualCAM 2018 for SolidWorks\Posts\MILL
Locked