Re-machining

All topics related to RhinoCAM
Post Reply
MS1476823257
Posts: 2
Joined: Tue Oct 18, 2016 1:42 pm

Re-machining

Post by MS1476823257 »

I updated to Rhinocam 2018 and Rhino 6 this morning and I can't get the re-machining operation to work on a profile. I was able to generate the path no problem with the same geometry in Rhinocam 2016 and Rhino 5. Any solutions or trouble shooting ideas?
MecSoft Support
Posts: 2405
Joined: Wed Aug 01, 2007 4:15 pm
Location: Irvine, CA, USA
Contact:

Re: Re-machining

Post by MecSoft Support »

If you could upload the file or email it to us at [email protected] we can take a look at it.
Post Reply