MecSoft Corporation
https://mecsoft.com:80/phpbb/

RhinoCam 2019 and WinCNC
https://mecsoft.com:80/phpbb/viewtopic.php?f=9&t=3774
Page 1 of 1
Author:  1333669497 [ Sat Sep 10, 2022 3:39 pm ]
Post subject:  RhinoCam 2019 and WinCNC

I Just recently upgraded my Laguna IQ Pro from a hand held controller to a WinCNC Controller and I'm having issues determining which post processor to use. Laguna gas sent me a post processor and loaded it and I've generated new G code with it. It loads and WNC show it in its control panel but when I try to run it I get a the following message: File Not Found - TU.Mac
Can anyone shed any light on this and what Win CNC is telling me?
I'm thinking I need a different extension. or that there is a secondary file I'm missing in order to run the G Code.
Thanks,
Chuck
Page 1 of 1 All times are UTC - 8 hours [ DST ]