MecSoft Corporation

Webinar: What's New in 2021 for RhinoCAM & VisualCAD/CAM!
Page 1 of 1
Author:  MecSoft Marketing [ Thu Jan 28, 2021 9:17 am ]
Post subject:  Webinar: What's New in 2021 for RhinoCAM & VisualCAD/CAM!

On Wednesday, January 27th, 2021, we hosted our open webinar featuring What's New in 2021 for RhinoCAM & VisualCAD/CAM. We thank everyone that joined us.

We covered:

- VisualCAD: Curve Boolean
- VisualCAD: Array Follow Curve
- VisualCAD: Text command previews and More.
- MILL Module: Machining SubD models in Rhino 7!
- MILL Module: 2 Axis Face Top operation
- MILL Module: 2 Axis Engraving with Bridges & Tabs
- 2 Axis Hole Pocketing & Hole Profiling with Hole Filter Selection
- MILL Module: 3 Axis Adaptive Roughing operation
- MILL Module: 3 Axis Cut Lift Transfers in High-Speed Machining (HSM)
- MILL Module: 3 Axis Horizontal Finishing with Start Points
- MILL Module: 4 Axis Projection Pocketing with Cut Levels
- MILL Module: 4 Axis Drive Surface Helical Cut Pattern
- MILL, TURN, Profile-NEST: New Clone Operation command
- MILL, TURN, Profile-NEST: Enhanced MOp Information Properties
- MILL, TURN, Profile-NEST: New Programmable Post Processing
- MILL, TURN, Profile-NEST: New Backlot & Diagnostics in Toolpath Editor
- TURN, New retracts with ID Turning Operations
- G-CODE Editor: More Stock Definitions
- G-CODE Editor: New Find/Replace features
- G-CODE Editor: New Simulation Functions
- NEST & Profile-NEST: New Sheets Commands

If you missed it, watch our webinar replay at:

Please let us know if you have any questions.

Thank you.
Page 1 of 1 All times are UTC - 8 hours [ DST ]