MecSoft Corporation

I am on Solidworks 2018. I have not used VCfSW or Solidworks for several months. When I logged in today I was notified that there was a more recent version of VC. I downloaded it, but chose not to install since it wanted me to remove old versions. I then tried to set up a job and there are no post processors in the pull down menu. I don't know what happened.

Select Post on the Program tab and this would display Set Post Processor Options dialog. Make sure folder where post processor files are located is pointing to C:\ProgramData\MecSoft Corporation\VisualCAM 2018 for SolidWorks\Posts\MILL