MecSoft Corporation
https://mecsoft.com/phpbb/

Extract 3d sketch
https://mecsoft.com/phpbb/viewtopic.php?f=9&t=2802
Page 1 of 1
Author:  dwilliams56 [ Mon Aug 06, 2012 8:33 am ]
Post subject:  Extract 3d sketch

In the Solidworks tutorial 4AxisPocketing_1 included with VM4SW how was 3DSketch2 created from the sketch wrapped around the cylinder?

Thanks,
Don
Author:  dwilliams56 [ Mon Aug 06, 2012 10:35 am ]
Post subject:  Re: Extract 3d sketch

I got the answer on the Solidworks forum. Well duh!

Start a 3D sketch, then use convert entities and select all the lines in the wrap.
Page 1 of 1 All times are UTC - 8 hours [ DST ]