VM4SW Enhancement request

All discussion related to VisualCAM for SolidWorks
Locked
davecranidge
Posts: 2
Joined: Sat Jun 05, 2010 11:28 am
Location: Scotland

VM4SW Enhancement request

Post by davecranidge »

Could we get a 'Select edges/chain' option that allows us to pick machining edges from the model instead of a sketch? This would be as well as the current 'Select Curves as Regions' and 'Select Flat Area features'? This would also be useful for selecting holes too for drilling ops.

PS What single line/stick font would you recommend for engraving text? I have successfully used V-Carving for larger text, but the results are not so good for small text around 3mm high.

DC
MecSoft Support
Posts: 2405
Joined: Wed Aug 01, 2007 4:15 pm
Location: Irvine, CA, USA
Contact:

Post by MecSoft Support »

Yes, edge selection is already in our enhancement list.

Regarding single line text, it is really up to your choice - there are no restrictions on what to use however.
davecranidge
Posts: 2
Joined: Sat Jun 05, 2010 11:28 am
Location: Scotland

Post by davecranidge »

Good.

It would be good to see what everyone else uses for an engraving font.

Do you have an estimated release date for the edge/chain selection?

DC
Locked