VisualMill and Solidworks 2007 sp0.0

All discussion related to VisualCAM for SolidWorks
Locked
Yendor
Posts: 1
Joined: Wed Sep 09, 2009 6:58 am
Contact:

VisualMill and Solidworks 2007 sp0.0

Post by Yendor »

I just downloaded VisualMill (yesterday 9-8-09). When starting it up, Solidworks starts OK. Checked that VisualMill is attached as an active add-in.

When I open a part, I get the VisualMill Splash Screen, which appears for a few seconds, then Solidwoks crashes and closes.

Any sugestions? Is VisualMill compatible with SW 2007 sp 0.0?
MecSoft Support
Posts: 2405
Joined: Wed Aug 01, 2007 4:15 pm
Location: Irvine, CA, USA
Contact:

Post by MecSoft Support »

VisualMILL for Solidworks works only on 2008, 2009 and 2010 (Beta). Previous versions are not supported. Sorry, this is because Solidworks changed their API quite dramatically after 2007.

P.S: FYI, I had the administrator move your posting to the appropriate forum.
Locked