Ramp profiling

All topics related to AlibreCAM

Ramp profiling

Postby MS1516313359 » Wed May 16, 2018 8:44 am

Is there anyway to do a ramp profiling cut instead of plunge between levels? I can't seem to find an option to do that.
MS1516313359
 
Posts: 7
Joined: Thu Jan 18, 2018 3:10 pm

Re: Ramp profiling

Postby MecSoft Support » Thu May 17, 2018 8:29 am

You can do this by setting the Rough depth and Rough depth/cut = total cut depth under cut levels tab and under entry/exit tab select Along Path and set the along path height = total cut depth and specify along path angle.
In the attached screen capture, Total cut depth is set to 1inch, Along path height to 1 and along path angle to 0.1
Attachments
Profile-Ramp-Capture.JPG
Profile-Ramp-Capture.JPG (69.15 KiB) Viewed 1574 times
MecSoft Support
 
Posts: 2464
Joined: Wed Aug 01, 2007 4:15 pm
Location: Irvine, CA, USA

Re: Ramp profiling

Postby nick952 » Thu Dec 06, 2018 3:05 am

This will not work if you have any Bridges/Tabs defined
Attachments
Capture1.JPG
Capture1.JPG (67.68 KiB) Viewed 1115 times
Capture.JPG
Capture.JPG (64.34 KiB) Viewed 1115 times
nick952
 
Posts: 1
Joined: Thu Mar 12, 2015 1:59 pm


Return to AlibreCAM Topics & Support

Who is online

Users browsing this forum: No registered users and 1 guest

cron