toolpath editing in RhinoCAM

All topics related to RhinoCAM
Post Reply
vectornormal
Posts: 3
Joined: Wed Aug 01, 2007 4:15 pm
Location: Kerrville, TX

toolpath editing in RhinoCAM

Post by vectornormal »

Can you graphically select a toolpath point to edit in the toolpath editor in RhinoCAM? I have a dense toolpath and there are two spikes that I would like to edit out and it is difficult to get to them by selecting block moves until I get to them. Is there a fast way to step through the toolpath to get to them?
MecSoft Support
Posts: 2405
Joined: Wed Aug 01, 2007 4:15 pm
Location: Irvine, CA, USA
Contact:

toolpath editing in RhinoCAM

Post by MecSoft Support »

No, in RhinoCAM you cannot graphically select the toolpath. You can only select using the list control in the toolpath editor dialog.
vectornormal
Posts: 3
Joined: Wed Aug 01, 2007 4:15 pm
Location: Kerrville, TX

toolpath editing in RhinoCAM

Post by vectornormal »

Thanks, I will add to this to the enhancement requests
Post Reply