Page 1 of 1

BUG IN TOOL LIST IN POST

Posted: Fri Apr 16, 2021 8:30 am
by MS1577730796
Hello,

I am seeing and bug with the tool list at the top of the post that is new in the 2021 RhinoCAM version. If you edit or change the tool in a tool path, the old tool or old version of the tool is still listed, i.e if you change tool numbers the tool will show up in the list as a the tool with the new number and as the tool with the old number. An old tool with also show if it is replaced with a different tool. I.E. if you change a 1/2" compression bit for a 1/2" down sheer in a tool path, they will both be listed as a tool in the post. Also, if you have multiple setups as you post the lower setups, the tools from the previous setups will also show in the tool list, instead of just the tools used in that setup.

Re: BUG IN TOOL LIST IN POST

Posted: Mon Apr 19, 2021 12:30 pm
by MecSoft Support
This issue has been fixed and should be part of the last service release update. Please make sure you have the most recent update installed. RhinoCAM - Check for updates. If you are still having an issue, please drop us an email to [email protected] and include the 3dm file.
Thank you.