Drag Knife Path

All topics related to RhinoCAM
Post Reply
MS1603318257
Posts: 7
Joined: Wed Oct 21, 2020 3:12 pm

Drag Knife Path

Post by MS1603318257 »

Hi,
I am trying to create a dragknife path. It does not run it as a steady path but adds swivel actions to each curve. I have alot of curves and what should take a short time is taking way too long.
Is the swivel action method the only way of programming the drag knives?
MecSoft Support
Posts: 2405
Joined: Wed Aug 01, 2007 4:15 pm
Location: Irvine, CA, USA
Contact:

Re: Drag Knife Path

Post by MecSoft Support »

Yes, Knife cutting operation would apply swivel actions for Drag knife swivel type. You can set the corner angle limit to control the corner swivel control under cut parameters tab. If you do not want swivel actions in your toolpath, you can try using 2 axis engraving.
Post Reply