Sloped flat surface pocketing

All topics related to RhinoCAM

Sloped flat surface pocketing

Postby MS1603318257 » Mon Dec 21, 2020 4:05 pm

I have a 1"x 10" wide slot that is on a slope. I cannot seem to figure out how to set a program to machine this. If I use 3D Horizontal Roughing, it puts a weird path in. If I use 3D Parralell Finishing, it does not do a cleanup pass.
MS1603318257
 
Posts: 6
Joined: Wed Oct 21, 2020 3:12 pm

Re: Sloped flat surface pocketing

Postby MecSoft Support » Mon Dec 28, 2020 10:07 am

Parallel finishing does not have a cleanup pass option. Cleanup pass is available in 3 axis projection pocketing which is part of our Advanced 3 axis module included with PRO & Premium configurations.
If you are on Standard or Expert configuration, you would have to program 2 parallel finishing operations by setting angle of cuts to 0 on one and 90 on the other. For control geometry use part Surfaces and pick the slope surface and set surface extent condition as TO.
MecSoft Support
 
Posts: 2528
Joined: Wed Aug 01, 2007 4:15 pm
Location: Irvine, CA, USA


Return to RhinoCAM Topics & Support

Who is online

Users browsing this forum: No registered users and 3 guests

cron