Dogbone depth control
Posted: Mon Dec 02, 2019 3:01 pm
Hello,
I find the software sends the bit further than necessary for the dogbones. If a square shape is to fit into a cutout (mortise & tenon type joint) then the bit only needs to go far enough so that the sharp corner of the tenon will slide into the joint. The dogbone goes further than that. Is there a way to tweak this in the current software?
I find the software sends the bit further than necessary for the dogbones. If a square shape is to fit into a cutout (mortise & tenon type joint) then the bit only needs to go far enough so that the sharp corner of the tenon will slide into the joint. The dogbone goes further than that. Is there a way to tweak this in the current software?