Dogbone depth control

All topics related to RhinoCAM
Post Reply
MS1553872302
Posts: 9
Joined: Fri Mar 29, 2019 8:12 am

Dogbone depth control

Post by MS1553872302 »

Hello,
I find the software sends the bit further than necessary for the dogbones. If a square shape is to fit into a cutout (mortise & tenon type joint) then the bit only needs to go far enough so that the sharp corner of the tenon will slide into the joint. The dogbone goes further than that. Is there a way to tweak this in the current software?
-Clint Chase
Chase Small Craft
MecSoft Support
Posts: 2405
Joined: Wed Aug 01, 2007 4:15 pm
Location: Irvine, CA, USA
Contact:

Re: Dogbone depth control

Post by MecSoft Support »

Could you please make the file available us so we can take a look at it. If you would like to email it, please send it [email protected]
Post Reply