MecSoft Corporation

I tried calling in but wonder if power or fires are effecting you guys.

When I set my feed rate reduction to 70%, it cuts the first part at the designated z-level with a feed rate of 70% as requested, but when it goes to cut the second part (I am using "level first") the feed rate jumps to 100% and stays there.

I hope the next version will solve this. Or if I am doing something wrong, please let me know.

Thanks

Our phone lines are working as we have been receiving calls.

When I set my feed rate reduction to 70%, it cuts the first part at the designated z-level with a feed rate of 70% as requested, but when it goes to cut the second part (I am using "level first") the feed rate jumps to 100% and stays there.
I hope the next version will solve this. Or if I am doing something wrong, please let me know.

Yes, this has been fixed for version 2020 release.