Page 1 of 1

Moving Tabs/Bridges

Posted: Sat Dec 29, 2018 6:18 pm
by 1135284354
Is there a way in RhinoCAM to manually move bridges/tabs where you want them?

Thanks,

Terry

Re: Moving Tabs/Bridges

Posted: Mon Dec 31, 2018 9:38 am
by MecSoft Support
Yes, you can do this by creating a pre-defined region and defining bridge points at desired locations. Please refer to our blog article on Bridges & tabs explored at : https://mecsoft.com/blog/bridges-tabs-explored/