Moving Tabs/Bridges

All topics related to RhinoCAM
Post Reply
1135284354
Posts: 3
Joined: Mon May 19, 2014 1:05 pm

Moving Tabs/Bridges

Post by 1135284354 »

Is there a way in RhinoCAM to manually move bridges/tabs where you want them?

Thanks,

Terry
MecSoft Support
Posts: 2405
Joined: Wed Aug 01, 2007 4:15 pm
Location: Irvine, CA, USA
Contact:

Re: Moving Tabs/Bridges

Post by MecSoft Support »

Yes, you can do this by creating a pre-defined region and defining bridge points at desired locations. Please refer to our blog article on Bridges & tabs explored at : https://mecsoft.com/blog/bridges-tabs-explored/
Post Reply