MecSoft Corporation
https://mecsoft.com/phpbb/

re-roughing
https://mecsoft.com/phpbb/viewtopic.php?f=7&t=3490
Page 1 of 1
Author:  MS1540396762 [ Wed Nov 21, 2018 1:46 pm ]
Post subject:  re-roughing

I have horizontal roughed out a part and then simulated it. When I go to re-rough with a smaller bit it re-cuts everything. So the hogged out material from the first operation is ignored and done over. Can someone tell me what I'm doing wrong?

thanks
Author:  MecSoft Support [ Wed Nov 21, 2018 5:08 pm ]
Post subject:  Re: re-roughing

Would you be able to upload the programmed 3dm file or email it to support@mecsoft.com so we could take a look at?
Page 1 of 1 All times are UTC - 8 hours [ DST ]