Page 1 of 1

re-roughing

Posted: Wed Nov 21, 2018 1:46 pm
by MS1540396762
I have horizontal roughed out a part and then simulated it. When I go to re-rough with a smaller bit it re-cuts everything. So the hogged out material from the first operation is ignored and done over. Can someone tell me what I'm doing wrong?

thanks

Re: re-roughing

Posted: Wed Nov 21, 2018 5:08 pm
by MecSoft Support
Would you be able to upload the programmed 3dm file or email it to [email protected] so we could take a look at?