MecSoft Corporation

I have a Shopbot and the g-code for a paddle I'm trying to cut out is not translating to my post processor for Shopbot. Any thoughts? G-code that it produces is below:

JZ, 0.0000
J2, 0.0000 , 0.0000
M5,,,,0,0
SO,1,1
'Engraving_Paddle
MS,2.92,2.92
M3,11.3602,4.1942,0.2500
M3,11.3602,4.1942,-0.0981
M3,11.3549,3.1942,-0.0981
M3,7.2090,3.2165,-0.0981
M3,11.3602,4.1942,0.2500
JZ, 0.0000
SO,1,0
J2, 0.0000 , 0.0000
M5,,,,0,0

As you also contacted our support team by email, we noticed your post processor was missing macros under circular interpolation for XY plane. We have sent you the updated your post processor.