Rhino G code for arc/circular engrave is not working

All topics related to RhinoCAM
Post Reply
MS1509397928
Posts: 1
Joined: Mon Oct 30, 2017 2:14 pm

Rhino G code for arc/circular engrave is not working

Post by MS1509397928 »

I have a Shopbot and the g-code for a paddle I'm trying to cut out is not translating to my post processor for Shopbot. Any thoughts? G-code that it produces is below:

JZ, 0.0000
J2, 0.0000 , 0.0000
M5,,,,0,0
SO,1,1
'Engraving_Paddle
MS,2.92,2.92
M3,11.3602,4.1942,0.2500
M3,11.3602,4.1942,-0.0981
M3,11.3549,3.1942,-0.0981
M3,7.2090,3.2165,-0.0981
M3,11.3602,4.1942,0.2500
JZ, 0.0000
SO,1,0
J2, 0.0000 , 0.0000
M5,,,,0,0
MecSoft Support
Posts: 2405
Joined: Wed Aug 01, 2007 4:15 pm
Location: Irvine, CA, USA
Contact:

Re: Rhino G code for arc/circular engrave is not working

Post by MecSoft Support »

As you also contacted our support team by email, we noticed your post processor was missing macros under circular interpolation for XY plane. We have sent you the updated your post processor.
Post Reply