Page 1 of 1

Cross hatching - what machining operation to use

Posted: Thu Dec 14, 2017 7:54 am
by MS1463418534
I am trying to create a crosshatch pattern on top of a curved surface. It is a knife handle. I don't know what 3D machining process to use. Attached is an image of the design.
Crosshatch.jpg
Crosshatch.jpg (147.56 KiB) Viewed 4069 times

Re: Cross hatching - what machining operation to use

Posted: Mon Dec 18, 2017 5:02 pm
by MecSoft Support
You can program the cross hatch pattern using engraving. This can be located under 2 axis methods.