Cross hatching - what machining operation to use

All topics related to RhinoCAM
Post Reply
MS1463418534
Posts: 2
Joined: Mon May 16, 2016 10:10 am

Cross hatching - what machining operation to use

Post by MS1463418534 »

I am trying to create a crosshatch pattern on top of a curved surface. It is a knife handle. I don't know what 3D machining process to use. Attached is an image of the design.
Crosshatch.jpg
Crosshatch.jpg (147.56 KiB) Viewed 4065 times
MecSoft Support
Posts: 2405
Joined: Wed Aug 01, 2007 4:15 pm
Location: Irvine, CA, USA
Contact:

Re: Cross hatching - what machining operation to use

Post by MecSoft Support »

You can program the cross hatch pattern using engraving. This can be located under 2 axis methods.
Post Reply