HI,
We are having problems while using "select holes on flat area" in a drill operation. If we select the surface by clicking near the isocurve, the hole locations are off by .001". If we select the surface away from the isocurve, they are right on.
This image shows the result. The numbers circled in red should be 0.0000. These holes are on Y 0.0000"
This image shows good numbers when selecting away from the Isocurve.
While the hole being off .001" on this part is not a big deal, for some parts it is. Not to mention the machine operators get nervous when the numbers on the machine display don't match the blueprints, so then they start asking questions and wasting time.
Why would clicking near and Isocurve cause the numbers to be off?
Thanks,
Brandon
Selecting Surface near Isocurve causes inaccuracies
-
- Posts: 31
- Joined: Mon May 19, 2014 1:05 pm
Selecting Surface near Isocurve causes inaccuracies
- Attachments
-
- Isocurve causing bad numbers.3dm
- (885.53 KiB) Downloaded 1017 times
-
- Posts: 2405
- Joined: Wed Aug 01, 2007 4:15 pm
- Location: Irvine, CA, USA
- Contact:
Re: Selecting Surface near Isocurve causes inaccuracies
We will take a look at this and let you know what is going on.
-
- Posts: 31
- Joined: Mon May 19, 2014 1:05 pm
Re: Selecting Surface near Isocurve causes inaccuracies
Hi,
Has anyone had a chance to look at this yet?
Thanks,
Brandon
Has anyone had a chance to look at this yet?
Thanks,
Brandon
-
- Posts: 2405
- Joined: Wed Aug 01, 2007 4:15 pm
- Location: Irvine, CA, USA
- Contact:
Re: Selecting Surface near Isocurve causes inaccuracies
It is the change of start points that is causing the issue. Development is looking into it to see why this is so.
-
- Posts: 2405
- Joined: Wed Aug 01, 2007 4:15 pm
- Location: Irvine, CA, USA
- Contact:
Re: Selecting Surface near Isocurve causes inaccuracies
Development has fixed this issue and will show up in the next release.