entry/exit move at each cut level

All topics related to RhinoCAM
Post Reply
hahn_rossman
Posts: 17
Joined: Sun Mar 09, 2014 9:35 am

entry/exit move at each cut level

Post by hahn_rossman »

I finally found the little check box under the parameter/cutlevels in the profiling operation which keeps the tool from being slammed down to the next level! Is there a way to set this as a global preference, rather than having to remember to click it each time? Thanks
Hahn Rossman
MecSoft Support
Posts: 2405
Joined: Wed Aug 01, 2007 4:15 pm
Location: Irvine, CA, USA
Contact:

Re: entry/exit move at each cut level

Post by MecSoft Support »

Yes, you can save the settings to a default knowledge base. Right mouse button click on the machining operation and select "Save as Defaults". Refer to the attached document for information on default Knowledge base.
Note: This information can also be found under RhinoCAM -MILL online help.
Attachments
RC2014_DefaultKB.pdf
(300.49 KiB) Downloaded 1075 times
MS1694454950
Posts: 9
Joined: Mon Sep 11, 2023 10:57 am

Re: entry/exit move at each cut level

Post by MS1694454950 »

I was just trying to save my machining defaults and got an error message. I am using RhinoCAM 23 and Rhino8, the message is "failed to write to external file"
Post Reply