RhinoCam2.0

All topics related to RhinoCAM
Post Reply
andkry
Posts: 2
Joined: Wed May 30, 2012 12:42 pm

RhinoCam2.0

Post by andkry »

Rhino3d file and RhinoCam2.0
Using Roland MDX-650 with tool changer and rotary unit.
Machine stop during finishing run - message reads: " wrong number of parameters " .
After pressing ENTER the bit cuts into the object milling along Y axis
in straight path.
Please help.
MecSoft Support
Posts: 2405
Joined: Wed Aug 01, 2007 4:15 pm
Location: Irvine, CA, USA
Contact:

Re: RhinoCam2.0

Post by MecSoft Support »

We would need to take a look at the Rhino part file (*.3dm) & the posted output file. Is your current post processor set to Roland CAMM-GL or Roland MDX 650 ATC in RhinoCAM?. Could you please upload the part file or email it to [email protected].
Post Reply