Post processer Question

All topics related to RhinoCAM
Post Reply
tomvaughan
Posts: 10
Joined: Sat Mar 22, 2008 10:57 am
Location: London

Post processer Question

Post by tomvaughan »

I was wondering if a post pacer post processer for visual mill would work for rhinocam?? And if not how easy would it be to re-write to work??
Mitch Heynick
Posts: 488
Joined: Wed Aug 01, 2007 4:15 pm
Location: Switzerland
Contact:

Post by Mitch Heynick »

Postprocessors for RhinoCAM and VisualMill should be interchangeable if they are the same general vintage. --Mitch
tomvaughan
Posts: 10
Joined: Sat Mar 22, 2008 10:57 am
Location: London

Post processer

Post by tomvaughan »

Thanks Mitch, how would I find out if they are the same general vintage?

I would imagine that they would be.
MecSoft Support
Posts: 2405
Joined: Wed Aug 01, 2007 4:15 pm
Location: Irvine, CA, USA
Contact:

Post by MecSoft Support »

All posts regardless of vintage are interchangeable between RhinoCAM and VisualMILL.
Post Reply