Polygonal Problem

briguy · Post by **briguy** » Fri Feb 15, 2008 4:48 am

I am able to simulate using Voxel, however when I swith to Polygonal, it says I should

"Simulation can not be preformed Recreate Stock Model and try again"
I try to re-create the stock, however this does work.

I am using Rhino 4.0 with RhinoCam Product Version: 1,0,1,3
When I used to use Rhino3.0, I was able to seamlessly change between simulation types.

Thanks,
Brian

Post by **MecSoft Support** » Fri Feb 15, 2008 10:34 am

I am assuming that you are using Stock from Selection option in RhinoCAM.

The Voxel model is a lot more forgiving when it comes to the input model while the polygonal model requires a water tight model. I would suggest creating a polygonal mesh of the stock and selecting this as the stock model.

briguy · Post by **briguy** » Fri Feb 15, 2008 1:44 pm

That explains it, my input model is not watertight.
Thanks,
Brian