Dogbone depth control

All topics related to RhinoCAM

Dogbone depth control

Postby MS1553872302 » Mon Dec 02, 2019 3:01 pm

Hello,
I find the software sends the bit further than necessary for the dogbones. If a square shape is to fit into a cutout (mortise & tenon type joint) then the bit only needs to go far enough so that the sharp corner of the tenon will slide into the joint. The dogbone goes further than that. Is there a way to tweak this in the current software?
-Clint Chase
Chase Small Craft
MS1553872302
 
Posts: 9
Joined: Fri Mar 29, 2019 8:12 am

Re: Dogbone depth control

Postby MecSoft Support » Tue Dec 03, 2019 3:28 pm

Could you please make the file available us so we can take a look at it. If you would like to email it, please send it support@mecsoft.com
MecSoft Support
 
Posts: 2475
Joined: Wed Aug 01, 2007 4:15 pm
Location: Irvine, CA, USA


Return to RhinoCAM Topics & Support

Who is online

Users browsing this forum: No registered users and 2 guests

cron