VisualMill Service Pack 9 Released!

All discussion related to the VisualCAD/CAM standalone product.
Post Reply
MecSoft Support
Posts: 2405
Joined: Wed Aug 01, 2007 4:15 pm
Location: Irvine, CA, USA
Contact:

VisualMill Service Pack 9 Released!

Post by MecSoft Support »

VisualMill 5.0 SP9 is released to fix user reported problems. To download the service pack please go to the Download section of our web-site and download Service Pack 9.

1)Horizontal Roughing for a specific geometry condition problem fixed
2)Regions stock crash under certain circumstances fixed
3)Point input crash with invalid input
4)Engraving speed-up
5)Helical output for Thread milling
6)Fix for clearance plane settings in 5-Axis mode
7)Fix for 4 Axis Zig method
8)Crash when not overwriting Mops but overwriting geometry
9)Profiling parameters dialog fix
10)4 Axis table rotate retract with environment variable
11)ATC support for Roland CAM-GL
12)Tabs at bottom using the VMILL_TABSATBOTTOM environment variable
13)Speed up viewing
14)Post improvement with support for Biesse post processor
15)Fix for Clear Flats in Horizontal Roughing to process flats at top of geometry if stock is higher than part
16)Units for DXF/DWG files handled correctly
17)Fix for crash for part transform under very specific circumstance
18)Grid settings are being saved across sessions
Post Reply