Hello, All.
I am trying to 2.5 profile mill 2 identical parts.
One is a copy that is rotated 180 deg around from the other.
I can change the start point on one easily, but when I try
to change it on the other part, the dot just goes back where it was before.
Any Ideas?
Thanks, John
Changing start point
-
- Posts: 2
- Joined: Wed Aug 01, 2007 4:15 pm
Changing start point
I got it by closing the drawing, then reopening it.
Still open for suggestions though.
Thanks, John
Still open for suggestions though.
Thanks, John