Pocketing in the YZ or XZ Plane

All discussion related to the VisualCAD/CAM standalone product.

Pocketing in the YZ or XZ Plane

Postby MS1609199493 » Wed Jan 13, 2021 11:49 am

Hello,

I'm relatively new to this software and trying to learn the ropes by programing a few example parts.

I ran into an scenario where I was running into errors generating a toolpath, and wanted to know if the software has this capability or not.

Please see the attached picture.

Part is set up as you would expect, on the large flat which makes most of the features accessible. But for the rectangular undercut opening, surfaces highlighted in blue, I'd like to pocket that area with an undercutting end mill from the side to create the undercut openings, and then use a flat end mill from the top to generate the larger square opening.

With the Expert version of VisualMill, is there a way to generate the toolpath I need?
Capture.JPG
Capture.JPG (68.82 KiB) Viewed 2510 times

Thanks!
MS1609199493
 
Posts: 1
Joined: Mon Dec 28, 2020 4:52 pm

Re: Pocketing in the YZ or XZ Plane

Postby MecSoft Support » Fri Jan 22, 2021 4:16 pm

Using a Facemill tool you could program this as T-slotting or engraving. For engraving you would have to offset the control geometry by the tool radius away from the pocket feature.
MecSoft Support
 
Posts: 2528
Joined: Wed Aug 01, 2007 4:15 pm
Location: Irvine, CA, USA


Return to VisualCAD/CAM Topics & Support

Who is online

Users browsing this forum: No registered users and 9 guests

cron