4th axis gcode

[osphoto]

I'm finally using my 4th axis ability and have it "running" on my machine.

However. When using the gCode, all my axis movements runs EXTREMELY SLOW!!!! It's got a speed setting of G06, if I change the code to G00 it of course runs faster. What am I missing in my 4th axis setup?

Thanks.

[DareBee]

check the programming manual for your machine.
What is the 4th axis feed rate supposed to be calculated in?
Does this compare to the outputted G code?
If it does then you must have a parameter in the machine control wrong or something.

[osphoto]

Not sure how to figure out what my 4th axis feed rate would be calculated in. No manual.

I'm sure it's a parameter issue, just no idea what parameter to even modify.