freemill

All discussion related to the VisualCAD/CAM standalone product.
Post Reply
nugget
Posts: 1
Joined: Thu Dec 22, 2011 9:23 pm

freemill

Post by nugget »

I appologise if I am in the wrong section but couldn't find a freemill specific section .

I have imported my part and it all looked good, picked up that the part was 232mm X 150 X 12.5mm but when I ran the code, it only made a part approx 9mm 4mm.

Have tried multipule times, uninstalled and reinstalled, but keep getting the same result.

It is like it has scaled it down but there is no facility for me to change the scale.

Any suggestions greatfully accepted. Cheers
Post Reply