Post Processor for Wire EDM

All discussion related to the VisualCAD/CAM standalone product.
Post Reply
JVidal
Posts: 72
Joined: Fri Jan 08, 2010 7:38 am
Location: Portugal
Contact:

Post Processor for Wire EDM

Post by JVidal »

I'm trying to setup a post for a WireEDM machine.

I've got it almost completely done, but I'm struggling to get a few codes on the correct place.

I need to insert specific M codes at the beggining and end of each profile
to be cut. These are M codes for cutting and inserting the wire.

In attach there's an example of what I need.

Any help is much appreciated.

Thanks.
Attachments
WIRE_EDM.ZIP
(394.38 KiB) Downloaded 1173 times
Best regards
JVidal
megclay
Posts: 17
Joined: Mon Oct 10, 2011 4:10 pm

Post Processor for Wire EDM (Charmilles)

Post by megclay »

this one for the Charmilles
works very good
I used Engraving
use with cutter comp
and post as iso file
megclay
Attachments
WIRE EDM Charmilles Robofill 310.zip
(2.14 KiB) Downloaded 1263 times
Post Reply