MecSoft Corporation
https://mecsoft.com/phpbb/

Major update for VisualCAM 1.0 & VisualMILL 6.0 is avail
https://mecsoft.com/phpbb/viewtopic.php?f=6&t=1690
Page 1 of 1
Author:  Administrator [ Wed Feb 18, 2009 3:40 pm ]
Post subject:  Major update for VisualCAM 1.0 & VisualMILL 6.0 is avail

A update for VisualCAM 1.0 & VisualMILL 6.0 is available now for immediate download at:

http://www.mecsoft.com/DownloadVisualMILL.shtml


Please completely uninstall VisualCAM and VisualMILL before installation of the update. Also make sure if you have any customized post processors to save them off before installation.

The version numbers on this update are VisualCAM 1.0.4.0 & VisualMILL 6.0.4.3.

For changes in VisualCAM please click on:

http://www.mecsoft.com/Downloads/VCAM1.0.4.0Changes.pdf

For changes in VisualMILL please click on:

http://www.mecsoft.com/Downloads/VM6.0. ... hanges.pdf
Author:  Administrator [ Thu Feb 19, 2009 7:31 pm ]
Post subject: 

Note the change in the release numbers. We had to update the release to VisualMILL 6.0.4.3 due to a critical fix in drill cycles output that went in on Feb 18th 2009. We apologize for any inconvenience caused.
Page 1 of 1 All times are UTC - 8 hours [ DST ]