Pre-release of SP6

[MecSoft Support]

SP6 is almost ready to be released. For you power users you can download it from www.mecsoft.com/VisualMill5_0.zip and unzip the contents to your VisualMill installation folder.

This SP6 fixes the following bugs:
1)Surface creation with poly-lines creates too many triangles
2)Edge picking fails in some cases
3)Surface edge creation failed if user did not pick close to the edge
4)Undo/Redo did not check for object references in Mops
5)Gouge when tool needed to travel below the bottom most Z coordinate of the part
6)Toolpath rotation, mirroring with copy now works correctly
7)User can control system beep volume by using speaker volume control
8)Profiling entry exits made more robust
9)Engraving UI for V-cutting now changes left to inside and right to outside
10)Engraving allows for 0 radius tip V cutter
11)Engraving, Profiling, Pocketing, Facing cut levels setting streamlined
12)A specific type of Rhino surface import problem fixed
13)Horizontal Finishing with optimize now does not cut below user specified Z values
14)Crash fixed when loading new part after performing an Undo operation
15)DXF ellipse import problem fixed
16)Stock/Box centering temporary display problem fixed
17)Import curves now adding objects to current layer instead of default layer