Lead In-2-1/2 Axis

All discussion related to the VisualCAD/CAM standalone product.

Lead In-2-1/2 Axis

Postby 1449157671 » Mon Oct 28, 2019 2:18 pm

Multi Z Profiling-I can only get the Radius Lead in on the first pass. A straight lead in is applied to each subsequent pass.

What am I missing?

Thank You
Attachments
multi-z.vcp
(322.75 KiB) Downloaded 9 times
1449157671
 
Posts: 21
Joined: Thu Dec 03, 2015 2:13 pm
Location: Michigan

Re: Lead In-2-1/2 Axis

Postby 1449157671 » Fri Nov 01, 2019 10:15 am

Seems like any answer would be better than no answer......
1449157671
 
Posts: 21
Joined: Thu Dec 03, 2015 2:13 pm
Location: Michigan

Re: Lead In-2-1/2 Axis

Postby MecSoft Support » Fri Nov 01, 2019 11:06 am

Thanks for the part file. We are reviewing it to determine a resolution for you.
MecSoft Support
 
Posts: 2472
Joined: Wed Aug 01, 2007 4:15 pm
Location: Irvine, CA, USA

Re: Lead In-2-1/2 Axis

Postby MecSoft Support » Fri Nov 01, 2019 11:18 am

Hello 1449157671,
Have a look at the attached revised part. The start point was causing the issue.
What did I do:
1.) Merge the curves into one curve (Curve Modeling > Merge)
2.) Moved the start point of the curve to midpoint of the side nearest when you had the start point previously (Curve Modeling > Start Point)
3.) Edit the mop, using the new curve and regenerate.
Attachments
multi-z-rev1.vcp
(317.33 KiB) Downloaded 8 times
MecSoft Support
 
Posts: 2472
Joined: Wed Aug 01, 2007 4:15 pm
Location: Irvine, CA, USA


Return to VisualCAD/CAM Topics & Support

Who is online

Users browsing this forum: No registered users and 1 guest

cron