Split Hollow Milling

Show us what you have done!

Split Hollow Milling

Postby Chris.Botha » Sat Jul 03, 2010 5:12 pm

i have been fielding lot of emails about "methods" or "strategies" when it comes to milling. I always answer similar to this.. If you had to make it by hand how would you go about it. most people would have about 10 different ways to do it. milling is the same. look at what you are making. how hard it will be to clean up. what material you are casting in etc. and develop a strategy based on your needs. no magic bullet strategy's im afraid ;)

I almost had this one grown but decided wall incline vs damn grower lines was worth the post casting cleanup :)

I was going to assemble in wax but decided i prefer to polish inside then seat solder in platinum after casting.
Image
Image
Image
Image
Image
Image
Image
Wine me, dine me, tram my mill for me!
Chris.Botha
 
Posts: 72
Joined: Thu Apr 08, 2010 1:22 am

Return to Toot Your Horn Gallery

Who is online

Users browsing this forum: No registered users and 1 guest

cron