MecSoft Corporation

Load RhinoCAM command
Page 1 of 1
Author:  leo [ Mon Mar 14, 2005 1:52 pm ]
Post subject:  Load RhinoCAM command

To load RhinoCam plugin after it unloaded can this command used

!-_PluginManager Load FileName RhinoCam

instead of using the menu -> tools->plugin manager.

This command can be put to a button.

Can be also downloadet from:


[Edited by leo on 14-Mar-05 12:52]
Page 1 of 1 All times are UTC - 8 hours [ DST ]