Post-Processor Tab

<< Click to Display Table of Contents >>

Navigation:  How To ... >

Post-Processor Tab

Use the Post-processor tab of the Machining Browser to select from your pre-defined list of post-processors.  There are two methods of adding post definitions to your list.  Both are described below.  Once you select a post-processor it will be indicated in the Machining Job.

1.Select Post from the Mill toolbar, double-click left-mouse-click Post under the Machining Job. or select the Post-processor tab of the Machining Browser.

Milling tab

vcc-post-button

or

vcc-post-selected

or

vcc-select-the-post-processor-tab

2.The Post-processor tab of the Machining Browser is activated.

3.Add a post to your Post-processors folder under Posts in Document.  Refer to the options below for the Post-processor tab.

tog_minusPost in Document

tog_minusDefault Posts